Workshop Warehouse Add A Circuit Blade Fuse Holders (EFH50)

Description

Genuine Workshop Warehouse · Part no. EFH50

The Workshop Warehouse EFH50 is an add-a-circuit extension board that fits into an existing standard blade fuse socket and gives an extra fused feed from that same fuse box position. It carries two fuses horizontally, covering the original circuit and the new one, so you gain a fused outlet without cutting or splicing any wires.

Good to know

• Will it fit my fuse box? It is made for a standard type blade fuse socket, so check that the socket you want to use takes standard blades.
• What goes back in the original slot? A fuse of the same rating as the one you took out of that socket.
• Do I need to cut any wires? No. The board takes its feed from the fuse box position without cutting or splicing.

Which one?

For a micro 2 blade fuse box, the Add-A-Circuit Micro 2 Blade Fuse Holder CONNECT 37189 comes with a pre-wired cable and a butt connector. To put an in-line fuse on a new wire run instead, the Workshop Warehouse In-Line Standard Blade Fuse Holders (EFH150) have a pre-wired loop for standard blade fuses.

Key features

• Plugs into an existing standard blade fuse socket
• Adds an extra fused feed from the same fuse box position
• Holds two fuses horizontally, for the original and the new circuit
• No cutting or splicing of existing wiring

Specification