Power Probe Circuit Tracer for Shorts and Open circuits ECT3000 (PPECT3000)

Description

Genuine Power Probe · Part no. PPECT3000

The Power Probe ECT3000 circuit tracer finds shorts to ground and open circuits without pulling looms apart. The transmitter puts a 4kHz signal on the circuit (6V-48V DC), and the receiver follows it, with signal locking that points towards the short and a distance bar. The receiver has an LED work light and switches off after 10 minutes idle.

Good to know

• When do I need it? When a fuse keeps blowing or a circuit is dead and you can't see why: it follows the wire through the loom to where the short or break is, without pulling everything apart.
• Does it work on lorries? The transmitter runs on 6V to 48V DC, so cars, vans, lorries, plant and boats.
• Anything to avoid? Never apply power or ground to airbag (SRS) wiring, usually in yellow connectors, and never feed 12V into a sensor's signal or 5V reference wire.

Which one?

This is our circuit tracer. To find which circuit a battery drain is on before tracing it, the Power Probe Fuse Monitor Parasitic Draw Fuse Monitor In-Circuit Tester (ppfuse) fuse monitor reads current through each fuse.

Key features

• Short and open circuit tracer
• Signal locking shows direction to the short
• Signal distance bar
• LED work light on receiver
• 6m transmitter power cable

Specification