Hylomar Nut Lock – 50ml (F/HY2143/050M)

Description

Genuine Hylomar · Part no. F/HY2143/050M

Safety: Warning. Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. May cause long lasting harmful effects to aquatic life. Read the label before use.

Hylomar Nut Lock is a 50ml medium strength, medium viscosity anaerobic thread-locker that cures fast once a nut or bolt is tightened and the air is shut out. It is the everyday thread lock for bolts that must not shake loose but will need undoing later: brake caliper carrier bolts, brackets, pulleys and mounts.

Good to know

• Why medium strength? It holds against vibration yet still lets the fastener come off with ordinary tools, so parts can be serviced without heat.
• Are the threads ready for it? Clean and degrease both threads; oil left on the bolt slows the cure and weakens the lock.
• How much should I use? A few drops on the engaged length of the bolt thread is enough; too much just runs out and stays liquid outside the joint.
• Can I use it on plastic or on oxygen fittings? No, anaerobic thread-lockers are for metal threads; keep them off plastics and away from oxygen systems.

Which one?

For studs you don't intend to remove, Hylomar Stud Lock (F/HY2170/050M) is very high strength; for a medium strength lock in a pocket bottle, J-B Weld Perma-Lock Medium Strength Threadlocker (24213A) is 13ml.

Key features

• 50ml bottle
• Medium strength, medium viscosity
• Fast curing, single part anaerobic
• Locks and seals threaded metal assemblies

Specification