Hylomar Stud Lock – 50ml (F/HY2170/050M)

Description

Genuine Hylomar · Part no. F/HY2170/050M

Safety: Warning. Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. May cause long lasting harmful effects to aquatic life. Read the label before use.

Hylomar Stud Lock is a 50ml very high strength anaerobic thread-locker with a low viscosity, so it wicks into close-fitting threads. It is for studs and fasteners meant to stay put for good, such as studs in engine blocks and gearbox cases, wheel studs pressed into hubs, and other permanent assemblies.

Good to know

• Will I get it undone again? Treat it as permanent: very high strength lock usually needs heating before the fastener will come out, so don't use it on bolts you remove at service.
• Why low viscosity? It runs into tight, close-fitting threads; on a loose or worn thread a thicker product fills the gap better.
• How do I fit a stud with it? Clean and degrease the stud and the hole, apply to the stud thread, screw in to its depth and leave it to cure before putting the nut on and torquing.
• Can it be used near plastics? Keep it to metal threads; anaerobic lockers can attack some plastics.

Which one?

For fasteners that will be removed later, Hylomar Nut Lock (F/HY2143/050M) is medium strength; for retaining bearings as well as locking studs, Granville Bearing Fit & Studlock (3096).

Key features

• 50ml bottle
• Very high strength
• Low viscosity to penetrate close-fitting threads
• Fast curing, single part anaerobic

Specification