Workshop Warehouse Repair Washers – Imperial 5/16 X 1 1/2 (HRW4)

Description

Genuine Workshop Warehouse · Part no. HRW4

Workshop Warehouse HRW4 repair washers take 5/16in bolts and are 1 1/2in across, a very wide bearing face in zinc plated steel, in a box weighing 2.49 kg. They suit plywood van linings, racking and shelving, roof box and tool box mounts, and fixings through soft or thin floors where a small washer would sink in.

Good to know

• Why use them for van racking? Bolting shelving through a thin floor or wall puts heavy, shaking loads on small areas; a 1 1/2in washer behind each bolt spreads them and resists pulling through.
• Should I seal floor bolts? Yes, through a van or trailer floor bed the washer on a sealant so water and road spray can't get in, and treat any bare drilled metal against rust first.
• Will a 5/16in washer suit M8 bolts? The hole is about 7.9mm, a close match for an M8 bolt; check the bolt passes freely before drilling a batch of holes.

Which one?

For less spread on the same hole, the Workshop Warehouse Repair Washers – Imperial 5/16 X 1 (M8 X 25) (HRW3); for an assorted box of washers and nuts, the Pearl Nuts, Bolts & Spring Washers – Assorted – Pack Of 240 Size Various (PXP113).

Key features

• Repair washers 5/16 x 1 1/2
• Very wide bearing face
• Zinc plated steel
• Strong and durable

Specification