Jubilee Hose Clips M/S 1X 30-40mm – Box of 10 (1XMS)

Description

Genuine Jubilee · Part no. 1XMS

Jubilee 1XMS packs 10 size 1X hose clips for hoses that measure 30mm to 40mm in diameter. Each one is the original Jubilee worm drive design in zinc protected mild steel, with a band threaded end to end for easy sizing, and Kitemarked to BS 5315:1991.

Good to know

• Can I fit it without disconnecting the hose? Yes. A worm drive clip can be undone fully and its band wrapped round a hose that is already on its pipe, so the hose does not have to come off to fit it.
• Should I check it again later? Check hose clips again once the hose has been through a warm-up and cool-down, as rubber can settle and leave a clip a little slack.
• Why does the band have threads all along? The thread runs the full length of the band, so the screw picks it up wherever the clip needs to close, giving fine adjustment across the range.

Which one?

Size 1X clips also come in the Jubilee Workshop Hose Clip Pack M/S – 143 Clips (HCP143MS), seven among 143, and ten in the Jubilee Hose Clip Handy Pack M/S – Pack of 100 (HP100MS). The Jubilee 1MMS (32-45mm) gives more range at the top end.

Key features

• Box of 10 size 1X clips
• For hoses 30mm to 40mm across
• Band threaded end to end
• Zinc protected mild steel
• Kitemarked to BS 5315:1991

Specification