Pearl Exhaust Clamp – 2 1/4in – Pack Of 10 Size 2 1/4in. (PEC10)

Description

Genuine Pearl · Part no. PEC10

Pearl PEC10 gives you ten U style exhaust clamps sized for 2 1/4in pipe, one of the larger sizes in the Pearl range. Each clamp goes over the overlap where a male pipe sits inside a female one and squeezes the joint closed. Measure carefully, as the Pearl sizes either side of 2 1/4in are close to it and look alike by eye.

Good to know

• Fitting a full system? Hang every section loosely in place first, line up the joints, then tighten the clamps working from the front of the car towards the back.
• What if the old nuts won't move? Soak them in penetrating oil and give it time, or cut the old clamp off; a fresh 2 1/4in clamp from this pack replaces it.
• Can a clamp fix a split pipe? No, it only holds and seals a joint; a split or rusted-through section needs a repair bandage or a new section of pipe.

Which one?

Bigger pipe? The Pearl Exhaust Clamp – 2 1/2in – Pack Of 10 Size 2 1/2in. (PEC11) is the next size up; for a slightly smaller pipe, the 2 1/8in Pearl PEC09.

Key features

• U clamp for exhaust joints
• 2 1/4in pipe size
• For larger pipework
• Pack of 10

Specification