Pearl Exhaust Clamp – 2 1/8in – Pack Of 10 Size 2 1/8in. (PEC09)

Description

Genuine Pearl · Part no. PEC09

A ten-pack of Pearl exhaust clamps for 2 1/8in pipe (PEC09). The U clamp fits over the joint where a female pipe end overlaps a male pipe, and tightening its nuts draws the outer pipe down so the two sections lock together and seal. Choose 2 1/8in only if the pipe measures that across its outside diameter.

Good to know

• Where exactly does it go? Over the overlapped part, close to the end of the outer pipe; if that end has slots cut in it, the clamp sits over the slots so they can close down.
• How should I tighten it? Turn the two nuts a little each in turn so the saddle seats square, and stop once the joint is firm; too much force can crush the pipe.
• Why buy ten? A full exhaust has several joints, and old clamps are usually too stretched or rusted to reuse, so spares in 2 1/8in save a second trip.

Which one?

Slightly smaller pipe: the Pearl Exhaust Clamp – 2in – Pack Of 10 Size 2in. (PEC08); slightly bigger: the 2 1/4in Pearl PEC10.

Key features

• U clamp for exhaust joints
• 2 1/8in pipe size
• Locks the overlap together
• Pack of 10

Specification