Pearl Hose Connector – Straight Push-Fit – 5mm – Pack Of 10 (PHC668)

Description

Genuine Pearl · Part no. PHC668

A pack of 10 Pearl straight push-fit connectors in the 5mm size, made of plastic, for joining two lengths of small hose end to end. They are handy for screen wash tubing, the kind of line that splits or gets cut when a bonnet, boot or washer jet is worked on, and need no tools to fit.

Good to know

• How do I repair a split washer tube with these? Cut out the damaged bit with a square cut, then push each tube end fully onto the connector; if the tube is stiff, warm the end in hot water first.
• Will 5mm suit my tubing? Connectors like this are sized by the bore of the tube, so check that the tube is a tight push fit over the connector; a loose fit will leak or pull off.
• Can I use them on fuel or compressor air lines? No, push-on plastic connectors are for low-pressure lines such as washer, water and breather tubes, not for fuel systems or air lines.

Which one?

For a mix of bigger straight connectors, the Workshop Warehouse Assorted Pack of Nylon Hose Connectors (AP71); to split a line in two, the Workshop Warehouse Hose Connectors – Equal Tees (PJ408).

Key features

• Straight push-fit connector
• 5mm size
• Pack of 10
• Plastic
• Joins two hoses end to end

Specification