Workshop Warehouse Ace W1 12Mm Hose Clips 50-70Mm Size 70 (3) (ACE1109)

Description

Genuine Workshop Warehouse · Part no. ACE1109

Ace W1 worm drive clips for hoses from 50 to 70mm, size 70 in Ace's numbering and size 3 in the older code. The 12mm band, housing and screw are zinc-plated mild steel to DIN 3017, for large coolant and air intake hoses on cars and vans that sit in a dry engine bay.

Good to know

• Zinc-plated or stainless at this size? Under the bonnet the zinc-plated W1 is fine; for a boat, a trailer or anything out in salt and rain, the stainless W4 version of this size lasts much longer.
• My hose measures right at 50mm. Should I use this? A reading at the very bottom leaves little screw to pull up on; a clip whose range puts 50mm nearer its middle will tighten better.
• How do I tighten it without damage? Turn the screw until the hose is gripped and the joint is dry, then stop; going further only cuts the band into the hose.

Which one?

The same size in stainless is the Workshop Warehouse Ace W4 Inox 12Mm Hose Clips 50-70Mm Size 70 (3) (ACE4103). Ace W1 sizes either side: 40-60mm (ACE1108) and 60-80mm (ACE1110).

Key features

• Range 50-70mm (size 3)
• 12mm wide band
• Zinc-plated mild steel
• DIN 3017 W1
• For large coolant and intake hoses

Specification