Carlyle Bottle Jack – 10T (CBOTJ10T)

Description

Genuine Carlyle · Part no. CBOTJ10T

A Carlyle 10T hydraulic bottle jack for lifting vans, 4x4s, trailers, plant and machinery, or for pressing and spreading jobs in the workshop. It has a leak proof cylinder, a safety valve that stops it lifting beyond its load, a 60mm extending screw to set the starting height, a welded base and a carry handle. TUV marked.

Good to know

• Will it go under my car? Bottle jacks stand taller when closed than a trolley jack, so they suit vans, 4x4s, lorries and plant better than low cars; measure the gap under your lifting point before you buy.
• How do I lift safely? Set it on firm, level ground under a solid lifting point, wind the extending screw up to take up the gap, then pump; once the vehicle is high enough, put axle stands under it before anyone goes near.
• How should I store it? Upright, with the ram fully down and the release valve closed; laying a bottle jack on its side can let air into the hydraulics, and then it lifts poorly until bled.

Which one?

For heavier loads such as lorries and large plant, the Carlyle Bottle Jack – 20T (CBOTJ20T) has the same features with twice the rating.

Key features

• 10T hydraulic bottle jack
• Leak proof cylinder
• Safety valve against overloading
• 60mm extending screw
• Welded base and carry handle
• TUV

Specification