Milwaukee Step Drill 6-35MM-1 Piece (48899335)

Description

Genuine Milwaukee · Part no. 48899335

Milwaukee's larger step drill (48899335) opens holes from 6 mm up to 35 mm in sheet steel, stainless, aluminium, copper, brass and plastics up to 4 mm thick. That range covers cable glands, panel-mount sockets and switches, and enlarging an existing hole to take a bigger grommet or fitting, with a deburred edge each time.

Good to know

• What drill do I need? It is made for high speed cordless drills. The three flats on the shank stop it spinning in the chuck, but keep a firm two-handed grip at the bigger steps, where the cutting load is highest.
• Can it enlarge an existing hole? Yes, that is one of its strengths: the tip centres in the old hole and each step opens it up evenly, with less risk of a ragged or out-of-round edge than a large twist drill gives.
• What can't it do? Material over 4 mm thick is beyond it, and before drilling a car panel check behind it for looms, pipes and the fuel tank.

Which one?

For small cable holes up to 12 mm, the Milwaukee Step Drill 4-12/1mm-1 Piece (48899301) is the smaller step drill.

Key features

• Holes from 6 to 35 mm with one bit
• Steel, stainless, non-ferrous metals and plastics
• For material up to 4 mm thick
• Two-flute ground edges for smooth cutting
• Each step deburrs as it cuts
• Laser-engraved size markings

Specification