Carlyle 3/8 Drive 10mm Open-End Crowfoot Wrench (CCF3810M)

Description

Genuine Carlyle · Part no. CCF3810M

Carlyle's CCF3810M is a 10mm open-ended crowfoot spanner with a 3/8in square drive hole. It fits on a 3/8in ratchet, extension bar or torque wrench, so you can reach a 10mm nut on a pipe or deep in a recess where a socket can't slide over. Mirror-polished chrome plating resists rust.

Good to know

• Does a crowfoot change my torque wrench reading? Not if you fit it at 90 degrees to the wrench handle. Fitted in line, it adds length and the setting has to be corrected.
• Can I use it to undo a seized 10mm nut? No, it grips only two flats like any open jaw. Free stuck nuts with a ring spanner, then use the crowfoot to run and torque them.
• What's it good for on a car? Small 10mm nuts on pipes, sensors and brackets that sit below other parts, where an extension bar reaches but a socket can't go over the fitting.

Which one?

The Carlyle 10 Piece 3/8 Drive Metric Crows Foot Spanner 10mm – 19mm (CCF10M) gives every size from 10mm to 19mm in one set, the simpler choice if you need more than one size.

Key features

• 10mm open-ended crowfoot
• 3/8in square drive
• Fits 3/8in torque wrenches
• For hard-to-reach nuts
• Mirror-polished chrome plating

Specification