Wot-Nots Fuse Holder – Glass Fuse Type – Black (PWN027)

Description

Genuine Wot-Nots · Part no. PWN027

Wot-Nots PWN027 is a black in-line holder for glass cartridge fuses. It comes wired, with a tag terminal on each end, and a spring inside holds the fuse against its contacts. It suits adding a fused feed to an accessory or replacing a cracked holder on an older installation.

Good to know

• Which glass fuses does it take? It is made for the commonly used sizes, but the length isn't stated, so take your fuse along or measure it against the holder before relying on it.
• Where does it go in the circuit? On the live feed, as close to the power source as practical, so the whole run of new cable is protected.
• Which fuse do I put in? The rating the accessory maker asks for, never higher than the cable you use can carry.

Which one?

For blade fuses rather than glass, the Workshop Warehouse In-Line Standard Blade Fuse Holders (EFH150) is the in-line choice. A spread of glass fuses to go in this holder comes in the Pearl Fuses – Assorted Glass – Pack Of 120 (PXP102).

Key features

• In-line holder for glass fuses
• Wiring included
• Tag terminals at both ends
• Sprung-loaded fuse contacts
• Black

Specification