Axcar Worm Drive Hose Clips 12 – 20 mm – Pack of 10 Size 12 – 20mm (AXC00162)

Description

Genuine Axcar · Part no. AXC00162

Ten Axcar worm drive clips with a 12 to 20mm range, in bright zinc plated mild steel with a perforated band. The range spans the smaller hoses under a bonnet, from low-pressure fuel hose to crankcase breather and small coolant hoses, so a pack is handy to keep in the garage drawer.

Good to know

• My hose is near the top of 12 to 20mm, will it do? It will grip, but a clip pulls most evenly with the hose near the middle of its range, so take the next size up if you have the choice.
• How tight should it go? Tighten until the hose is held firmly on the pipe and doesn't weep, then stop; going further cuts into the rubber and shortens the hose's life.
• Where on the hose should it sit? Just behind the raised bead or flare on the pipe, with the band square across the hose and not over its cut end.

Which one?

For hoses at the top of this range, the Axcar 12-22mm (AXC00163) or 16-25mm (AXC00164); for smaller lines, the 10-16mm (AXC00161).

Key features

• Pack of 10 worm drive clips
• Takes hoses from 12mm to 20mm
• Perforated band
• Bright zinc plated mild steel

Specification