Pearl Exhaust Clamp – 1 3/4in Size 1 3/4in. (PEC06C)

Description

Genuine Pearl · Part no. PEC06C

Pearl's PEC06C is a 1 3/4in U-bolt exhaust clamp, roughly 44mm, made to close a joint where one exhaust pipe slides inside another. The size tells you the pipe diameter it suits and allows the right length of thread to pull the saddle up tight, so a 1 3/4in pipe gets a firm, even grip.

Good to know

• My pipe measures between two sizes, which do I pick? Go by the outside of the outer pipe: a clamp too large runs out of thread before it bites, and one too small will not slip over the joint.
• Where on the joint should the clamp sit? Over the section where the pipes overlap; if the outer pipe has slits cut in its end, set the clamp across them so it can squeeze them closed.
• Do I need sealant too? A clamp holds the joint, while exhaust assembly paste fills the gaps between the pipes, so use both for a joint that will not blow.

Which one?

Close sizes are the 1 5/8in (PEC04C), the 1 7/8in (PEC07C) and, in a box of ten, the Pearl Exhaust Clamp – 1 11/16in – Pack Of 10 Size 1 11/16in. (PEC05).

Key features

• 1 3/4in exhaust clamp
• U-bolt with saddle and nuts
• Joins a male pipe inside a female pipe
• Pack of 10 also made

Specification