Pearl Exhaust Clamp – 2 1/4in Size 2 1/4in. (PEC10C)

Description

Genuine Pearl · Part no. PEC10C

Pearl PEC10C clamps 2 1/4in exhaust pipe, about 57mm, closing a joint where one pipe slips inside another. Thread length on the U-bolt is matched to this diameter, so the saddle can draw the outer pipe tight onto the inner without running out of thread, giving a firm hold on larger-bore systems.

Good to know

• Should I size up if unsure? No: measure the outer pipe and match it, because a clamp one size too big may run out of thread before it grips, and one too small will not go over.
• Why does a joint blow even with a new clamp? Often the pipes are not fully overlapped, or the ends are rusted thin; push them fully home with assembly paste, and replace a section whose end has rotted.
• Is it worth reusing the clamp I took off? Rarely; a used U-bolt has stretched and its nuts may seize, so a new one is the reliable choice for a joint that has to stay tight.

Which one?

For a larger pipe choose the 2 1/2in clamp (PEC11C) or the Pearl Exhaust Clamp – 2 1/2in – Pack Of 10 Size 2 1/2in. (PEC11); a slightly smaller one takes the 2 1/8in (PEC09C).

Key features

• Clamp for 2 1/4in exhaust pipe
• U-bolt thread matched to the diameter
• Joins male and female pipes
• Pack of 10 also made

Specification