Carlyle 10mm 6 Point Combination Wrench (CCWFP010M)

Description

Genuine Carlyle · Part no. CCWFP010M

Photo shows the range. Size as stated.

Carlyle's CCWFP010M is a 10mm combination spanner with a 6-point ring, the choice for 10mm heads that are rusty, painted over or already a little rounded. The ring sits at a 15 degree offset and the open end has anti-slip jaws with radiused corners. Packed length is 159 mm, the same as its 12-point twin.

Good to know

• Why a 6-point ring rather than 12? Six points push on the flat faces of the hex instead of its corners, so a corroded 10mm head is far less likely to round off under load.
• The bolt is seized – what helps? Penetrating oil left to soak for a while frees a stuck nut better than heaving on the handle; then pull steadily with the ring end.
• How should I pull on it? Pull the spanner towards you rather than pushing, so if it slips your knuckles don't hit the engine or bodywork.

Which one?

For a full run of 6-point sizes the Carlyle 13 Piece 6 Point Combination Wrench Set 7mm to 19mm (CCW613M) covers 7mm to 19mm; where swing is very short, the 12-point Carlyle 10mm 12 Point Combination Wrench (CCWFP110M) re-grips sooner.

Key features

• 6-point ring grips the flats
• 15 degree offset ring end
• Anti-slip open jaw with radiused corners
• Hot-forged steel
• Colour-filled size marking

Specification

Brand	Carlyle
Part number	CCWFP010M
Weight	0.04 kg
Packed size	159 x 23 x 7 mm
Size	10mm
Ring end	6 point, 15 degree offset