Carlyle 1in Drive 152mm Length Impact Socket Extension (CIEXT0106)

Description

Genuine Carlyle · Part no. CIEXT0106

The Carlyle CIEXT0106 is a heavy 1in drive impact extension, 152mm long, in black phosphate chrome molybdenum steel. 1in drive is the size used on commercial vehicles and plant, so this short bar goes between a 1in impact wrench and a big socket on lorry, bus and tractor wheel nuts where the nut sits a little below the wheel face.

Good to know

• Will it fit my impact wrench? Only if the wrench has a 1in square drive; on a 3/4in gun you need a reducer or 3/4in extension instead, and a 1/2in car gun is far too small for this kit.
• Which sockets go with it? 1in drive impact sockets; 32mm and 33mm are common lorry wheel nut sizes, so check the nut before buying the socket to go on the end.
• Why the short length? The less length between gun and socket, the more of the hammer energy reaches the nut and the easier the heavy gun is to hold straight.
• Any safety points with 1in tools? The gun, bar and socket together are heavy, so keep feet clear, wear gloves and eye protection, and check the drive is fully home before you start.

Which one?

For a nut set deeper in the wheel, the Carlyle 1in Drive 250mm Length Impact Socket Extension (CIEXT0110) or the 330mm CIEXT0113 give more reach; to go on the end, the Carlyle 1 Drive 33mm Deep P 6 Point Impact Socket (CISD0133M) is a 1in deep impact socket.

Key features

• 1in drive, 152mm long
• Chrome molybdenum alloy steel
• Black phosphate finish
• Built for impact and air tools
• Chamfered opening for quick socket fitting

Specification