Jubilee High Torque Clips S/S 80-100mm – Pack of 10 (HT100P)

Description

Genuine Jubilee · Part no. HT100P

Jubilee HT100P brings 10 high torque clips in all stainless steel for big hoses from 80mm to 100mm in diameter. With double the torque of an ordinary worm drive clip and over twice the band tension, they are meant for heavy suction hose and pipe joints shaken by constant vibration.

Good to know

• Is this the clip for a wire reinforced suction hose? Yes, that is the job it was designed for: the extra band tension pulls a stiff spiral wound hose tight where a standard clip would run out of grip.
• What torque should I use? The recommended figure is 17 Nm (150 lb. in); tighten to that and stop, since going further cuts into the hose without sealing it any better.
• Why all stainless steel? Stainless steel clips suit marine, salted and exposed places, so these hold up on outdoor pipework or vehicles that see winter road salt.

Which one?

For hoses from 40 to 70mm, the Jubilee HT070P is the same high torque clip in a smaller size. For a standard 85-100mm clip on ordinary rubber hose, see the Jubilee 4XSSP in stainless or the Jubilee 4XMSP in mild steel.

Key features

• Pack of 10, sized 80-100mm
• Double the torque of a standard worm drive clip
• More than twice the band tension
• Recommended torque 17 Nm (150 lb. in)
• All stainless steel construction

Specification