Pearl Exhaust Clamp – 1 5/8in – Pack Of 10 Size 1 5/8in. (PEC04)

Description

Genuine Pearl · Part no. PEC04

Pearl's 1 5/8in exhaust clamp comes as a pack of ten (PEC04), for clamping the overlap where one exhaust section slides inside the next. Each U clamp draws the outer pipe in around the inner so the joint can't pull apart or leak gas. Sized by pipe diameter, with thread enough on the bolt to close on 1 5/8in pipe.

Good to know

• Why do neighbouring sizes matter so much? The Pearl range goes up in small steps around 1 5/8in, so measure the pipe's outside diameter carefully; a clamp a size too big may run out of thread before it grips.
• How do I make the joint gas-tight? Spread exhaust jointing paste round the overlap before you push the pipes together and clamp them, then run the engine and listen for blowing.
• Is it safe to work under the car? Let the exhaust cool completely first, and support the car on ramps or axle stands, never on a jack alone.

Which one?

Next size down is the Pearl Exhaust Clamp – 1 1/2in – Pack Of 10 Size 1 1/2in. (PEC03); next up, the Pearl Exhaust Clamp – 1 11/16in – Pack Of 10 Size 1 11/16in. (PEC05).

Key features

• U clamp for exhaust joints
• 1 5/8in pipe size
• Closes the outer pipe on the inner
• Pack of 10

Specification