Carlyle 1/2 Drive Digital Flex Head Torque Wrench with Angle Indicator 16 to 339Nm (CDTW12FL)

Description

Genuine Carlyle · Part no. CDTW12FL

A 1/2 inch drive digital torque wrench from Carlyle with a flex head and angle indicator, reading 16 to 339Nm (12.5 to 250 lbf.ft). It shows torque in Nm, ft-lbs, in-lbs and kg-cm as well as degrees, so it handles torque-to-yield bolts that need an angle after the torque. Accuracy is +/- 2% both ways for torque and +/- 1% of reading for angle, with a 12 LED indicator for low light.

Good to know

• When do I need the angle reading? For torque-to-yield bolts, such as many cylinder head and crank pulley bolts, which are tightened to a torque and then turned a set angle; without it you need a separate angle gauge.
• Will it do my wheel nuts? Yes: most car wheel bolts and nuts are tightened to between about 100 and 140Nm, inside its range; always use your vehicle's own figure.
• Click or digital? A click wrench is simpler and needs no battery; the digital one reads several units and angle, and its LEDs show when you are close.

Which one?

The 3/8 inch version is the Carlyle 3/8 Drive Digital Flex Head Torque Wrench with Angle Indicator 6.77 to 134Nm (CDTW38FL). A click type 1/2 inch wrench is the Carlyle 1/2 Drive Torque Wrench Click Fix Head 67 to 338Nm (CTW12RH1).

Key features

• Digital torque wrench, 1/2in drive
• 16 to 339Nm
• Angle indicator
• Nm, ft-lbs, in-lbs, kg-cm and degrees
• Flex head, 36 tooth

Specification