Pearl Hose Clips S/S 2 40-55mm – Pack of 10 (PSHC09)

Description

Genuine Pearl · Part no. PSHC09

Ten Pearl stainless steel worm drive hose clips in size 2, adjusting from 40 to 55mm. Stainless won't rust in the wet, so these are the clips to choose for boats, trailers, washer and drain hoses, and any car hose that lives in road salt, where a plated steel clip would corrode and seize.

Good to know

• Is stainless worth it under the bonnet? In a dry engine bay plated steel does the job; stainless pays off where the clip sees salt, standing water or the weather, and it is easier to undo years later.
• How do I check 40-55mm is right? Measure the hose's outside diameter once it is pushed on the pipe; a reading in the middle of the range leaves the screw room to pull up tight.
• How do I stop it cutting the hose? Tighten the screw only until the hose grips the pipe and the joint stays dry; extra turns just drive the band into the rubber.

Which one?

The mild steel version for dry places is the Pearl Hose Clips M/S 2 40-55mm – Pack of 10 (PHC09X). Stainless sizes either side: 2A 32-50mm (PSHC08) and 2X 45-60mm (PSHC10).

Key features

• Size 2, 40-55mm
• Pack of 10
• Stainless steel, won't rust
• Worm drive band
• For marine, trailer and salted use

Specification