Milwaukee Hex socket rail+clips 1/2 350mm-1 Piece (4932480448)

Description

Genuine Milwaukee · Part no. 4932480448

A 350mm Milwaukee socket rail with clips, made for 1/2in drive sockets: the heavy ones you use on wheels, suspension and subframes. The rail has fixing holes top and bottom, so it can be screwed to a wall board, a cabinet side or van racking, and its clips hold chrome or impact sockets, standard or deep, by the drive square.

Good to know

• How many sockets will it take? The clip count is not listed and spacing depends on the socket sizes; big deep 1/2in sockets need more room between clips than small ones, so lay them out before you fix the rail.
• Can I mount it upright on a wall? Yes, the holes on top and bottom let you screw it down flat or fix it to a vertical surface. The ball in each clip keeps heavy sockets from sliding off.
• Will it carry my 3/8in sockets too? Not on these clips, because the ball must sit in a 1/2in square hole. The rails are interchangeable, so a separate 3/8in rail sits alongside it.

Which one?

For 3/8in drive sockets the matching rail is the Milwaukee Hex socket rail+clips 3/8 350mm-1 Piece (4932480446), and for 1/4in ones the Milwaukee Hex socket rail+clips 1/4 350mm-1 Piece (4932480444).

Key features

• 350mm rail with clips for 1/2in drive
• Fixing holes on top and bottom
• Ball detent clips hold heavy sockets
• Chrome or impact, standard or deep
• End caps come off to rearrange clips

Specification