J-B Weld JB Weld High Strength Threadlocker (27113UK)

Description

Genuine J-B Weld · Part no. 27113UK

Safety: Danger. Causes skin irritation. Causes serious eye irritation. May cause cancer. May cause respiratory irritation. Read the label before use.

J-B Weld High Strength Threadlocker is a permanent locking compound for nuts, bolts and studs that must not shake loose, for fastenings from 1/4in to 1in. It holds up to 149°C, so it suits brackets, studs and bolts on the engine and chassis that see vibration and heat.

Good to know

• Will I be able to undo the bolt later? Not easily: high-strength threadlocker usually needs heat on the fastener before it can be undone. If the bolt comes out at service time, a medium-strength threadlocker is the better choice.
• How do I apply it? Degrease the threads, put a few drops on the bolt where the nut will sit, then tighten to the usual torque; leave it to cure before the part goes back into service.
• Where shouldn't I use it? On fasteners the workshop manual says to fit dry or replace, on plastic parts, and on threads bigger than 1in, which are outside its range.

Which one?

This is the only threadlocker in this range; for bonding parts rather than locking threads, see J-B Weld Original Syringe (50165UK).

Key features

• High-strength threadlocker
• Permanent lock on bolts and studs
• Resists vibration
• Up to 149°C
• Fastenings 1/4in to 1in

Specification