Pearl Exhaust Clamp – 1 3/4in – Pack Of 10 Size 1 3/4in. (PEC06)

Description

Genuine Pearl · Part no. PEC06

Pearl PEC06 is a pack of ten U clamps for 1 3/4in exhaust pipe, used to hold a sleeved joint where a male pipe slides into a female one. The 1 3/4in size is the pipe's diameter, and each U bolt has thread enough to pull the clamp tight on it, so the joint stays together and stops blowing.

Good to know

• Is 1 3/4in my size? Measure the outside diameter of the pipe, not the old clamp; if your callipers read in millimetres, divide by 25.4 to get inches and check it comes to 1 3/4in.
• Where should the clamp sit? On the overlap, near the end of the outer pipe, so it closes that pipe down onto the inner one; slotted pipe ends take the clamp over the slots.
• Can I reuse the clamp that came off? Old clamps are usually stretched or rusted, so a new one is the safer choice whenever a joint is taken apart and remade.

Which one?

Pipe slightly smaller? The Pearl Exhaust Clamp – 1 11/16in – Pack Of 10 Size 1 11/16in. (PEC05) is the next size down; slightly bigger, the 1 7/8in Pearl PEC07.

Key features

• U clamp for exhaust joints
• 1 3/4in pipe size
• Holds a male pipe inside a female pipe
• Pack of 10

Specification